库车山前盐层随钻扩眼尺寸优化研究

doi:10.3969/J. ISSN.1006-768X.2022.03.07

钻采工艺 ›› 2022, Vol. 45 ›› Issue (3): 37-41.DOI: 10.3969/J. ISSN.1006-768X.2022.03.07

库车山前盐层随钻扩眼尺寸优化研究

周小君¹,刘洪涛¹,何世明^2,3,周波¹,赵力^1,汤明^2,3,黄韬^2,3

１中国石油塔里木油田分公司２西南石油大学３油气藏地质及开发工程国家重点实验

出版日期:2022-05-25 发布日期:2022-05-25
作者简介:周小君（1989-），工程师，2014年毕业于西南石油大学油气井工程专业，现在塔里木油田从事科研管理和工程方案编制工作。
基金资助:
国家自然科学基金项目“基于水化进程的泥岩地层井壁坍塌机理研究”（编号：51904260）和塔里木油田科研项目“山前复合盐膏层及目的层扩眼技术研究”（编号：201020081030）联合资助。

Study on Size Optimization of Reaming while Drilling in Salt Layer of Kuche Piedmont

ZHOU Xiaojun¹,LIU Hongtao¹,HE Shiming^{2 ,3},ZHOU Bo¹,ZHAO Li¹,TANG Ming²,HUANG Tao^2,3

1. CNPC Tarim Oilfield Company, Korla, Xinjiang 841000, China; 2. Southwest Petroleum University, Chengdu, Sichuan 610500, China; 3. State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Chengdu, Sichuan 610500, China

Online:2022-05-25 Published:2022-05-25

摘要/Abstract

摘要： 塔里木盆地库车山前构造盐层广泛发育，盐层井段241.3 mm井眼钻井过程中阻卡井漏问题频发，采用扩眼技术增大环空间隙可有效解决阻卡和井漏复杂，但实际扩眼尺寸范围较大，不利于盐层扩眼技术的推广应用。文章以盐岩力学参数和蠕变规律为基础，利用有限元仿真模拟得到考虑盐岩蠕变、固井顶替效率和机械钻速综合影响下的扩眼尺寸优化推荐结果，并进行现场应用。结果表明：综合考虑盐岩蠕变、固井顶替效率和机械钻速等因素影响下的推荐扩眼尺寸为254~270 mm；应用井盐层段241.3 mm井眼随钻扩眼至266.7 mm，绝大部分井段井眼尺寸大于266.7 mm，工程参数与未扩眼邻井同层段相比差异小；扩眼后同返速下固井ECD最高下降0.052 g/cm³、固井质量合格率及优质率较同区块邻井分别提高 49%和39%，表明库车山前盐层段将井眼扩眼至266.7 mm是科学合理的。研究成果对山前盐层段高效科学推广扩眼技术提供了理论和技术支撑。

关键词: 库车山前构造, 盐层扩眼, 随钻扩眼, 扩眼尺寸优化, 盐岩蠕变

Abstract: Salt layer is widely developed in Kuche Piedmont of Tarim Basin, the problem of stuck and leakage occurs frequently in 241.3mm wellbore in salt layer during the drilling process. Using reaming technology to increase annular clearance can effectively solve the complexity of stuck and leakage, but the range of wellbore enlargement is various, which is not conducive to the popularization and application of salt-layer reaming technology. In this paper, based on mechanical parameters and creep mechanism of salt rock, dynamic simulation is used to obtain the results of the optimal wellbore reaming size considering the influence of creep mechanism of salt rock, cementing displacement efficiency and rate of penetrate before the field application is carried out. The result shows that the recommended wellbore enlargement size is 254~270 mm. The result of application well whose wellbore size is enlarged from 241.3mm to 266.7mm shows that after reaming the wellbore size of most section is greater than 266.7mm, the engineering parameters compared with the un-reamed adjacent wells of the same section have nearly no difference. The ECD decreases by 0.052 g/cm3 at the same return speed, and compared with adjacent wells in the same block, the qualified rate and excellent rate of cementing increase by 49% and 39% respectively. Field application indicates that enlarging the wellbore from 241.3mm to 266.7mm in salt layer of Kuche Piedmont is scientific and reasonable. The results provide theoretical and technical support for popularizing the reaming technology in the salt layer of Kuche Piedmont.

Key words: Kuche Piedmont, reaming in salt-layer, reaming while drilling, optimization of reaming size, creep of salt rock

周小君, 刘洪涛, 何世明, 周波, 赵力, 汤明, 黄韬, . 库车山前盐层随钻扩眼尺寸优化研究[J]. 钻采工艺, 2022, 45(3): 37-41.

ZHOU Xiaojun, LIU Hongtao, HE Shiming , ZHOU Bo, ZHAO Li, TANG Ming, HUANG Tao, . Study on Size Optimization of Reaming while Drilling in Salt Layer of Kuche Piedmont[J]. Drilling & Production Technology, 2022, 45(3): 37-41.

参考文献

[1]董萌.克拉苏构造盐膏层钻井提速措施研究与应用[D].成都:西南石油大学,2017.
DONG Meng. The research and application of the high quality and high speed drilling of the salt layer in Kelasu[D].Chengdu: Southwest Petroleum University, 2017.
[2] 唐庚,赵超杰,李军,等.钻井液作用下膏盐层井径变化规律研究[J].钻采工艺, 2020, 43(6):24-27.
TANG Geng, ZHAO Chaojie, LI Jun, et al. Research on wellbore diameter variation of gypsum-salt formation under the effect of drilling fluid[J] . Drilling & Production Technology, 2020, 43( 6) : 24-27.
[3] 吴泓璇.阿姆河右岸巨厚盐膏层蠕变规律及安全钻井研究[D].成都:西南石油大学,2018.
WU Hongxuan. Study on creep mechanics and safe drilling techniques for large salt-gypsum layers in Amudarya right bank block[D] . Chengdu: Southwest Petroleum University, 2018.
[4] 卿山盟. 小井眼随钻扩眼技术研究[D].成都:西南石油大学,2015.
QING Shanmeng. Research on reaming while drilling technology in slim hole[ D] . Chengdu: Southwest Petroleum University,2015.
[5] 林海,邓金根,许杰,等.复合盐膏层井眼缩径机理与对策分析[J] . 断块油气田, 2018, 25(6): 793-798.
LIN Hai, DENG Jingen, XU Jie, et al. Borehole shrinkage mechanism and countermeasure analysis of composite salt-gypsum layer [J] . Fault Block Oil & Gas Field,2018, 25(6):793-798.
[6] 孙一流.塔里木油田石炭系盐膏岩地层套损机理及对策研究[D].北京:中国石油大学(北京),2017.
SUN Yiliu. Research on mechanism and countermeasures of casing damage of carboniferous salt gypsum rock layer in Tarim oilfield[ D] . Beijing: China University of Petroleum(Beijing),2017.
[7] 岳家平,武治强, 耿亚楠,等.高压盐膏层定向井段固井技术对策及应用[J].中外能源, 2019,24 (1):34-39.
YUE Jiaping, WU Zhiqiang, GENG Yanan, et al. Cementing technology countermeasure and application in directional well section of salt gypsum layers with high pressure[J].Sino-Global Energy, 2019, 24(1):34-39.
[8] 祝效华,郭大强,童华,等.采用随钻扩眼技术提高海相气藏盐岩夹层套管服役的安全性[J].天然气工
业, 2016, 36(10):93-101 .
ZHU Xiaohua, GUO Daqiang, TONG Hua, et al. Improvement of the service safety of casing for inter-bedded salt rocks in marine gas reservoirs by reaming-while-drilling technology [J] . Natural Gas Industry, 2016, 36(10):93-101 .
[9] 娄尔标,刘洪涛,李宁,等.岩盐蠕变套管柱服役边界条件确定[J] .石油管材与仪器,2021,7 (1) :56-58.
LOU Erbiao, LIU Hongtao, LI Ning, et al. Determination of casing service boundary condition of rock salt creep[J] . Petroleum Tubular Goods & Instruments, 2021 , 7(1) : 56-58.
[10] 许强,梁院科,李明忠,等.不同套管偏心条件下的固井顶替界面稳定机理研究[J].水动力学研究与进展,2018, 33(3):314-321 .
XU Qiang, LIANG Yuanke, LI Mingzhong, et al. Research on mechanism of cementing displacement interface stability under different casing eccentric conditions [J] .Chinese Journal of Hydrodynamics,2018, 33(3):314-321 .
[11] PELIPENKO S, FRIGAARD I A. Mud removal and cement placement during primary cementing of an oil well-part 2; steady state displacements [J] . Journal of Engineering Mathematics, 2004,48(1):1-26.
[12] PELIPENKO S, FRIGAARD I A. Two dimensional computational simulation of eccentric annular cementing displacements[J].IMA Journal of Applied Mathematics,2004, 69( 6) : 557-583.
[13] LI Mingzhong, WANG Ruihe, WANG Chengwen, et al.Study on flow characteristic of non-Newtonian fluid in eccentric annulus [J] . Research Journal of Applied Sciences, Engineering and Technology, 2013, 6 (13) :2451-2458.
[14] 孔令豪,何世明,汤明,等.考虑钻柱屈曲的环空压降计算[J] .断块油气田, 2019, 26(3) : 375-379.
KONG Linghao, HE Shiming, TANG Ming, et al. Calculation of annular pressure drop considering drill string buckling[J].Fault Block Oil & Gas Field, 2019, 26(3) : 375-379.
[15] 徐生江, 刘可成, 姚旭洋, 等. 椭圆井眼偏心环空赫巴流体平板层流模型[J] . 石油机械, 2020, 48(12): 27-34.
XU Shengjiang, LIU Kecheng, YAO Xuyang, et al. Plate laminar flow model of Herbert fluid in eccentric annulus of elliptical wellbore [J].China Petroleum Machinery,2020, 48( 12) : 27-34.

库车山前盐层随钻扩眼尺寸优化研究

Study on Size Optimization of Reaming while Drilling in Salt Layer of Kuche Piedmont

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 4

编辑推荐

阅读统计

本文评价

[1]	崔龙兵, 胡亮, 席步祥, 阮臣良, 程光明, 赵建军. 射频识别随钻扩眼器的研制与应用[J]. 钻采工艺, 2020, 43(4): 71-74.
[2]	葛伟凤，陈　勉，金　衍，张　飞，卢运虎. 水平井造斜段盐膏层套管等效应力分析[J]. 钻采工艺, 2013, 36(2): 87-89.
[3]	石晓兵, 刘鹏, 吴应凯, 陈平,李黔,罗勇. RWD随钻扩眼下部钻具组合的强度分析[J]. 钻采工艺, 2007, 30(1): 7-9.
[4]	马清明, 王瑞和, 许俊良. 一种新型机械式PDC随钻扩眼工具[J]. 钻采工艺, 2006, 29(1): 68-70.